Axminster WS1000TA User Manual page 10

Assembly
Line up the edge of the steel plate (C3) with the 'T' slot machined into the sliding table A see fig 3. Slide the
support table assembly (C) onto the sliding table & position it to the far side. Tighten the two lift and shift handles
(C2) to clamp the assembly in position (See fig 4).
Fig 3
Slide the table assembly C1 onto the sliding
table A
Step 2
Sliding Table Extention Assembly (Optional Accessory Order No: 950505)
Locate the pivot arm (B6) with the four bolts & washers, line the holes in the mounting bracket with pre-drilled
holes to the side of the spindle moulder (A) & secure using the bolts and washers (See figs 5-6). Locate the
extention table support rod (B7), slide the support rod (B7) through the pre-drilled hole in the pivot arm (B6) and
secure using the nuts & washers (See figs 7-8).
Fig 5
B6
Line up pivot arm bracket to
the side of the machine
Continues Over....
10
C
Locate the extention table (B1), extention table
fence (B2), lift and shift handles with M6
washers (B3) & the pre-drilled steel pin plate
(B4).
Slide the steel pin plate into the machined 'T'
slot to the left hand side of the sliding table
(See fig 9).
Pull out the extention table support arm (B6)
see figs 10 and 11, offer up the machined slots
in the table (B1) with the pins (B4), see figs 12
and 13, locate the two lift and shift handles
(B3) and screw them through the pre-drilled
holes in the table (B1) into the pre-drilled steel
pin plate (B4), see fig 14. Tighten the lift and
shift handles (B3).
A
Clamp the table in position by tightening the
two lift and shift handles C2
Fig 4
C2
Fig 6
Using a spanner, tighten the
five bolts