Warranty... Thank you for purchasing one of Axminster’s growing family of woodworking products. The CSC500C Chuck Set is engineered and manufactured to the highest quality standards. You will find this product an essential accessory to your workshop. This product is warranted against defects in material and workmanship for a period of one years for all components.
11. Keep clean and lubricate with at light oil as needed. What’s in the Box... Model Number: CSC500C A CSC500C Chuck set (pre threaded for 1" x 8tpi) B 1. Set (4 piece) of #2 round jaws (shipped pre-mounted to chuck) C 1. Hex wrench D 2. Tightening levers E 1.
Chuck System Description... A. Main body: designed to hold all jaws as an assembly. B. Carrier: to which the top jaws are each attached with one or two hex screws. (#4 jaw has toungue which must mate with groove) C.Jaws: attached to the carrier, used for gripping the wood piece to be turned. D.
1. Wipe the inside of the threads and the outside of the adapter to insure both surfaces are clean. 2. Use the furnished 3/4"xl6tpi adapter if necessary. 3. Hold the chuck in your hand, screw and tighten the adapter into the bottom threaded portion of the chuck. Chuck Adapter www.axminster.co.uk...
Mounting the Chuck to Your Lathe... Screw the completed assembly onto your lathe. The chuck should go on effortlessly with no binding. Screw the chuck all the way until the adapter face contacts the shoulder of the lathe spindle. Lock the spindle, slightly unscrew the chuck and give it a firm spin. This will snap the chuck firmly in place.