Axminster WS1000TA User Manual page 20

Illustration & Parts Description
Fig 41
Spindle moulder control panel
Fig 43
Reversing selector switch
NOTE: The machine is equipped with a FORWARD/REVERSE switch as shown in figure 43. You will find
many instances that it is necessary to flip the cutter over and reverse the cutter rotation.
CAUTION: BEFORE TURNING THE SELECTOR SWITCH, MAKE SURE THE
MACHINE IS AT A COMPLETE STOP!
NOTE: Turning the reversing selector switch to the (L) position the motor will run in a forward motion & the
spindle will turn counter-clockwise. Turning the selector switch to the (R) position the motor will run
reverse & the spindle will turn clockwise (See fig 43).
Fig 45
Sliding table locking knob,
locked in the out position
20
Off
On
NVR ON/OFF switch
Emergency stop shroud, slap the shroud
down to stop the machine.
Pull the locking knob & twist
Fig 42
Fig 44
Fig 46