Fig 68; Changing The Spindle Moulder Speed - Axminster WS1000TA User Manual

DISCONNECT THE MACHINE FROM THE MAINS SUPPLY!
Open the motor access door to the front of the machine, by removing the two caphead screws, see figs 68 & 69,
lower the spindle to it's lowest point, if not done so already. Locate the 10mm allen key (G), loosen the caphead
bolt (H) on top of the motor, pull the motor tension lever (I) out, to allow the belt to go slack & reposition the belt
on the pulleys as required. When you are happy push back the tension lever (I) and tighten the caphead bolt (H)
to keep the tension (See figs 70,71 & 72).

Fig 68

Fig 70
Caphead screw
Close the access door, raise the spindle,
reconnect the machine to the mains supply.
Fig 72
Give the machine a 'quick' burst check ( i.e.
quick ON-OFF) to ensure everything is O.K. If
everything is satisfactory, continue to use the
machine.

Changing the Spindle Moulder Speed

Motor access door
G
I
Fig 69
Fig 71
H
25