Speco D24GS Operation Instruction Manual page 57

Highlight the DVR – Initiator Node Name box and press the
enter the DVR name to be registered on the iSCSI device.
Highlight the iSCSI – Target Address box and press the
the iSCSI device that you are connecting to the DVR.
Highlight the iSCSI – Target Port box and press the
the iSCSI device that you are connecting to the DVR.
Highlight the iSCSI – Target Nodes box and press the
Highlight Discover and press the
connected to the DVR in the Target Node Name list, and selecting a specific device from the list displays its full name
in the Full Node Name box. Selecting a desired device and selecting OK allows you to use the selected device for
recording.
Highlight the box beside iSCSI – CHAP Authentication and press the
NOTE: Setting up the Authentication will be required to access the iSCSI device that uses the CHAP Authentication
function.
The box beside Session displays the current connection status between the DVR and iSCSI device.
NOTE: The system restarts automatically after changing the iSCSI settings.
When using an iSCSI device, refer to the device manufacturer's instructions for proper settings.
Recorded video and audio on an iSCSI device might play properly depending on network conditions.
CAUTION: The iSCSI device should be connected directly to the iSCSI connector on the rear panel
of the DVR.
button. Use the arrow buttons to enter the IP address of
button. Use the arrow buttons to enter the port number of
button, and the Target Nodes screen appears.
button. Proper iSCSI settings will display the list of iSCSI hard disk drives currently
Highlight Use and press the
Highlight the box beside User/Password and press the
A virtual keyboard appears allowing you to enter the user ID and
password.
button. A virtual keyboard appears allowing you to
button. An Authentication screen appears.
button to toggle between On and Off.
Digital Video Recorder
button.
47