Monitoring; Figure 12 : System - Monitoring Setup Screen - Speco D24GS Operation Instruction Manual

Operation Instruction
The Format column displays whether the device is used for recording (Record), archiving (Archive) or not (Not Using).
Not formatted indicates the device is not formatted.
that video clips can be saved on a DVD RW.
NOTE: The DVR does NOT support USB hard disk drives with a version lower than 2.0.
iSCSI devices cannot be formatted and used for archiving.
iSCSI and eSATA devices cannot be partitioned for CD or DVD burning.
The Information column displays whether the device is being used or not. Other indicates the device has been used
for another DVR.
Highlight the box in the Information column for the desired storage device and press the
to check the time information about recorded data.
CAUTION: Do NOT disconnect the USB cable or the power from the device while copying video clips.
If the USB cable is disconnected while copying video clips, archived data might be lost.
Highlight the boxes beside Mirror and press the
Dest. (destination) disks selected from internal hard disk drives. Refer to the Chapter 4 – Disk Mirroring for further
information on setting up disk mirroring.

Monitoring

Highlight Monitoring and press the
26
indicates when the device has temporary space set aside so
Highlight the box in the Format column for the desired storage device and
press the button. You will be able to format the device for recording or
archiving. When selecting Not Using from Use As and highlighting the
Format button, the device will not be used for either recording or archiving.
You can also set aside space to store temporary files for CD or DVD burning
by selecting Partition – CD/DVD Burn.
If you want to erase recorded data on the selected device,
highlight Clear and press the
whether or not you want to delete the data.
If you want to use a USB hard disk drive, highlight Use and
press the
Don't Use and press the
the device.
button. The DVR can be set up to mirror Source disks to designated
button, and the Monitoring setup screen appears.
Figure 12 : System – Monitoring setup screen.
button. You will be able
button. You will be asked
button after connecting the device. Highlight
button if you want to stop using