Axu-Mca (/Pb), Axu-Mcv (/Pb), And Bb-Mtp Unimount Enclosure (Plasterboard) - AMX Color Active-Matrix LCD Instruction Manual

Note
The mini-touch panel must
always be installed with the
release slot located at the
bottom.
Figure 8
AXU-MCA/PB and BB-MTP
UniMount enclosure for
plasterboard
Color Active-Matrix LCD Mini-Touch Panels
Fasten the BB-MTP to the solid surface with the mounting screws supplied with
9.
the enclosure.
Connect the AXlink and video wiring to the mini-touch panel. Refer to Wiring
10.
the Mini-Touch Panels for wiring diagrams and pinout descriptions.
Fasten the mini-touch panel to the BB-MTP with the #6-32 screws provided with
11.
the enclosure.
Insert the engraved overlay back into the bezel.
12.
Connect the AXlink wiring to the AMX Control System, and video wiring to the
13.
video source. The mini-touch panel will beep when you apply power.
AXU-MCA (/PB), AXU-MCV (/PB), and BB-MTP UniMount enclosure
(plasterboard)
Mount the AXU-MCA (/PB), AXU-MCV (/PB), and BB-MTP into a plasterboard
surface (or equivalent). Figure 8 shows the AXU-MCA/PB and BB-MTP UniMount
enclosure for plasterboard.
Stud mounting
holes
BB-MTP UniMount enclosure
Plasterboard surface-
mounting flanges
Knockout
Expansion clips
AXU-MCA/PB bezel
Release slot
Engraved overlay
Installing Mini-Touch Panels 9