Table of Contents
Advertisement
Figure 9
Mini-touch panel and BB-MTP
cutout dimensions
10
Installing Mini-Touch Panels
Cut the surface according to the cutout dimensions shown in Figure 9.
1.
Insert a flat-blade screwdriver into the release slot on the mini-touch panel' s
2.
bezel and remove the engraved overlay.
Lay the mini-touch panel facedown onto a soft cloth and remove the four screws
3.
from the low profile back box. Remove the back box and discard.
Place the BB-MTP into the cutout and mark the threaded insert positions as
4.
shown in Figure 9.
Remove the BB-MTP and drill four #6-32 insert holes. Then, place a threaded
5.
insert into each hole.
Color Active-Matrix LCD Mini-Touch Panels
Advertisement
Table of Contents
