Table of Contents
Advertisement
Figure 178
Lithium batteries location
Caution
There is a danger of explo-sion
if you replace the battery
incorrectly. Replace the battery
with the same or equivalent type
recommended by the
manufacturer. Dispose of used
battery according to the
manufacturer' s instruc-tions.
Never recharge, disassemble,
or heat the battery above 212 ° F
(100 ° C). Never solder directly
to the battery or expose the
contents of the battery to water.
126
Replacing the Lithium Batteries
Flip the mini-touch panel face down onto a soft cloth, and remove the four
3.
Phillips-head screws from the bottom panel. Then, gently remove the panel.
Gently rotate the circuit card backwards until you can lay it down flat with the
4.
batteries exposed. Figure 178 shows the location of the lithium batteries on the
circuit card.
Connector side of circuit card
Carefully slide one battery out of its socket, and insert the new battery.
5.
Rotate the circuit card back to the original position and place it in the mini-
6.
touch panel housing. Do not insert any the mounting screws.
Plug the mini-XLR AXlink and optional RCA connectors back into the mini-
7.
touch panel for approximately 1 minute. Then, remove the connectors from the
panel again.
Gently rotate the circuit card backwards until you can lay it down flat with the
8.
batteries exposed.
Carefully slide the other battery out of its socket, and insert the new battery.
9.
Rotate the circuit card back to the original position and place it in the mini-
10.
touch panel housing.
Lithium batteries
Color Active-Matrix LCD Mini-Touch Panels
Advertisement
Table of Contents
