Axu-Cp Or Axu-Cp/Pb, And Bb-Tp2; (Solid Surfaces) - AMX AXT-CP Instruction Manual

Note
The touch panel must always
be installed with the release
slot located at the bottom.
Figure 6
AXU-CP and BB-TP2
UniMount enclosure
8 Installing the Touch Panel
Fasten the touch panel and low-profile back box to the surface using the #6-32
6.
machine screws supplied with the enclosure.
Insert the engraved overlay back into the bezel.
7.
Connect the AXlink wiring to the AMX Control System and RS-232 wiring
8.
(optional) to the external RS-232 device. The touch panel will beep when you
apply power.
AXU-CP or AXU-CP/PB, and BB-TP2 (solid surfaces)
Mount the AXU-CP or AXU-CP/PB, and BB-TP2 ( Figure 6) into a solid surface:
BB-TP2 UniMount enclosure
Stud mounting
holes
Cut the solid surface according to the cutout dimensions shown in Figure 7.
1.
Solid surface mounting
flanges
Knockout
AXU-CP bezel
Release slot
Engraved overlay
Color Passive-Matrix LCD Touch Panels