Microcom 424 Operator's Manual page 168

^Ax deletes the graphics in slot #x.
^A ^D COMMAND
XX 106 Save ASCII Graphics to RAM.
This command is intended for legacy support only. Microcom Corporation
recommends using the ^D107 command instead of the ^D106.
xxyy 107 Save Compressed GRAPHICS to RAM.
The special ^Axxyy^D107 code is put at the beginning of the GRAPHIC
download file by the bit map converter program. The ^Axxyy tells the printer
the overall size of the file according to this format:
xx = the number of additional 64KB sectors in the GRAPHIC file set
yy = CGN # (1-255)
XX 108 Serial Communication Port Command (Non-volatile).
This command tells the printer how to determine the HOT comm. port on the
next power-ON. This command is stored in FLASH and only takes effect on
the next power cycle.
XX 109 Serial Communication Port Command (Volatile).
This command tells the printer to immediately switch to a specific comm. port.
This command is NOT stored in FLASH, so it will be lost when the printer
powers OFF.
XX 110 General Purpose command.
The printer has a special mode of communication for General Purpose control
environments. Communication is over the Ethernet port and uses a special
one control byte protocol.
XX 111 Kiosk Cutter Mode.
0 Disable Kiosk Cutter Mode.
1 Enable Kiosk Cutter Mode.
2 Turn on partial Kiosk Cutter Mode.
This is a special mode that can be used to avoid media "curling" when left
under the drive roller for extended time. The printer feeds the media forward a
programmable amount (ref ^D112) so that the leading edge of the media is out
from under the drive roller. This helps prevent the leading edge of the ticket
being curled up by the drive roller, which leads to paper jams going into the
cutter.
These are the steps the printer takes when a ticket is to be printed:
This mode is useful in Kiosk applications where the media may normally rest
under the driver roller for long times and become curled.
12-12
1) ticket media is retracted from the "Idle" position into the
printer,
2) ticket is printed,
3) ticket is advanced to the cutter & cut
224/424 Operator's Manual - 880027-1000