Microcom 424 Operator's Manual page 166

using the ^D39 auto-size commands. The ^Axx value sets the point (0-255) at
which the printer detects a gap, blow-hole and/or blackline. When the printer
is powered-up or reset, this command defaults to a value of 30 if using the
transmissive sensor and 100 if using the reflective sensor. Although the
default value should work properly with most media types, it is a good idea to
place this command at the beginning of all format files in order to guarantee
that the printer will properly detect your media's registration mark. If this value
is not set correctly the printer may false sense a GAP or report an invalid
>LOW STOCK< error.
^A ^D COMMAND
XX 92 Set Starting Slice Number: This command adjusts the number of
slices (dot rows) generated before the printer starts moving the label stock.
X 93 Load Control Code Recognition Status:
0 Enable control code recognition
1 Disable control code recognition
X 94 Set Slice Buffer Size:
2 ^A2^D94
3 ^A3^D94
4 ^A4^D94
5 ^A5^D94
6 ^A6^D94
Valid values for Ax are 2 - 6.
XX 95 Load Advance/Retract Distance: Used in conjunction with cutter and
dispense command. The ^Axx specifies the amount to advance after printing
and then retract to dot row. The count is given in dot increments.
XX 96 Load Advance Delay: The ^Axx specifies the amount of delay, in
milliseconds, the printer waits before retracting to dot row in cutter and
dispense modes.
X 97 Tag/Tear Dispense Mode
0 Disables Tag/Tear Mode
1 Advance after every label.
2 Advance after copies count.
3 Advance when idle.
X 98 Peel-n-Dispense Mode
0 Disable Peel-n-Dispense
1 Enable Peel-n-Dispense
12-10
88Kbytes (default size)
192Kbytes
256KBytes
320KBytes
384KBytes
224/424 Operator's Manual - 880027-1000