Microcom 424 Operator's Manual page 170

^A ^D COMMAND
118 Home Cutter: When this command is used, the printer will cycle the cutter
gear to determine the location of the gear and position it in the home position.
XX 119 Display Memory Allocation.
This command shows how all of the RAM and FLASH memory is being used
XX 120 AutoLoad Delay Selection.
0 AutoLoad Delay = 0 seconds(no delay).
XX AutoLoad Delay = xx milliseconds.
The AutoLoad Delay is the amount of time that the printer waits after detecting
that media has been put into the printer before it starts feeding it in.
121 Top Of Form Command.
This command causes the printer to do a Top Of Form operation:
b) media is advanced until the leading edge is detected by the reflective
c) media is retracted 0.512" to place the leading edge of stock under
122 Display Available FLASH memory.
This command is used to display how much FONT/GRAPHICs flash memory
is available.
XX 123 Set TOF Retract Distance.
0 Use the DEFAULT value of 1.084" (230 dpi = 220 steps or dot rows; 330 dpi =
325 steps or dot rows).
1−−>900 Valid retract distances, measured in dot rows
XX 124 Set Stock Out Threshold.
This command is non-volatile and is used to set the stock out threshold value
(0-255) at which the printer detects an out of stock or >LOW STOCK< error
condition. The threshold is typically set to a value that is 80 percent of the
transmissive sensor reading when no media is detected by the transmissive
sensor. This value is calibrated at the factory and should not require
adjustment unless the transmissive sensor has been replaced.
XX 125 Location of Euro Character.
This command controls the location of the euro character, and is only used
with 48-466 emulation mode.
xxyy 127 Save FONTS to RAM.
X 129 Auto Set Threshold.
This command will cause the printer to scroll 1350 dots, determine the proper
threshold value, and set the nonvolatile threshold for proper registration. The
^Ax selects either reflective or transmissive detection.
12-14
"Top Of Form" sensor,
the print head.
224/424 Operator's Manual - 880027-1000