Installing And Configuring Lansafe Ups Software - Intergraph InterServe 600 Series System Setup

To change startup type for device drivers that control PC Card hard disks:
1. Open Devices in the Windows NT Control Panel. The Devices dialog displays.
2. Highlight the device in the Device list; then select Startup. The Device dialog displays.
3. Under Startup Type, select the appropriate startup type; then select OK.
4. In the Devices dialog, select Close.

Installing and Configuring LanSafe UPS Software

Systems equipped with a Uninterruptible Power Supply (UPS) are shipped with LanSafe III
software to configure and monitor operation of the UPS.
To install LanSafe III UPS software:
1. Insert the LanSafe III CD-ROM into the CD-ROM drive.
2. In the Windows NT File Manager, run
drive.
3. When the Welcome dialog displays, select Install.
4. Select Full Installation to install the software onto the server. If you are installing
LanSafe III onto a remote system, select Remote Services. Then select Continue.
NOTE If you select Remote Services, Setup asks for a location to install the files. Select the default
location, or enter an alternate pathname; then select Continue. After the software is installed,
shut down and restart the system.
5. When asked if the computer is part of a UPS group, select No; then select Continue.
6. Select the Generic UPS Code II for the UPS type; then select Continue.
7. Select the COM port to be used; then select Continue.
8. Enter an access code to safeguard the UPS operation; then select Continue.
9. Select Shutdown Timing Operations; then select Continue.
10. Select Yes for the Autoload Option; then select Continue.
11. A dialog asks for a location to install the files. Accept the default location, or enter an
alternate pathname; then select Continue.
12. When the software is installed, shut down the system.
13. Verify that the serial cable is connected as described in the LanSafe III software manual,
and that all AC power cables are connected to AC receptacles on the back of the UPS.
. in the
SETUP EXE NTWIN
15
directory on the CD-ROM