Installing System Software; Before You Begin; Windows Nt Server 4.0 - Intergraph InterServe 600 Series System Setup

5 Installing System Software

Complete the procedure outlined in this chapter if you must re-install Windows NT Server
software on your Intergraph system. Most of these steps are described in more detail in the
operating system documentation delivered with your system.

Before You Begin

Have the following items available:
u
The information you recorded under "Preparing for Windows NT Setup" in Chapter 1,
"Getting Started."
u
Operating system software CD-ROM, associated diskettes, and documentation. Make
sure you have the Setup diskettes delivered with the operating system.
u
Backup diskettes you created according to instructions in Chapter 1, "Getting Started."
u
Backup diskettes and documentation delivered with any expansion boards purchased from
Intergraph.
u
The Late-Breaking News document delivered with your system.
System software required during re-installation may be on backup diskettes, or on the
operating system software CD-ROM. If you do not have a backup diskette containing a
specific driver or other system software product, look for the driver or system software
product on the operating system software CD-ROM or on backup diskettes delivered with an
expansion board. Check the Intergraph Bulletin Board Service (IBBS) and vendor bulletin
boards frequently for new and updated drivers.
Review the Late-Breaking News document delivered with your system for any additional tasks
you may have to perform during re-installation.

Windows NT Server 4.0

CAUTION If your system is equipped with an internal RAID subsystem or an external RAID disk array,
and your system drive is part of the RAID set, you must select the RAID level and configure
the RAID before you start Windows NT Setup and install Windows NT Server. Refer to the
InterRAID documentation for instructions on configuring the RAID disk array. Then return to
this document and install Windows NT Server.
43