Installing Qfe Update Software; Creating An Emergency Repair Disk; Installing The Ecc Memory Driver - Intergraph InterServe 600 Series System Setup

Installing QFE Update Software

If your system was shipped with Quick-Fix Engineering (QFE) update software, you created a
QFE diskette using Version Manager (refer to Chapter 1 for information about Version
Manager). Insert the QFE diskette into the floppy drive. Refer to the
QFE diskette for instructions to update the system.

Creating an Emergency Repair Disk

The files on the Emergency Repair Disk can restore a damaged registry to its original contents
(that is, at the time Windows NT was installed), along with the standard Windows NT drivers.
CAUTION Once you have created all of your user accounts and have finished configuring the system,
Intergraph recommends that you create an Emergency Repair Disk using the
Use this utility to update the Emergency Repair Disk any time you change your system's
configuration. You should also make and keep a backup copy of the Emergency Repair Disk.
Refer to the operating system documentation and Help for information on creating and using
an Emergency Repair Disk.

Installing the ECC Memory Driver

After you configure the Windows NT Server operating system, you may install the ECC
Memory Driver and its configuration utility for your InterServe server. Install the driver from
the diskette you created using Version Manager (refer to Chapter 1 for information about
Version Manager).
To install the ECC Memory Driver and configuration utility:
1. Insert the diskette containing the ECC Memory Driver software into the floppy disk drive.
2. In the Windows NT File Manager, run
3. When prompted, type the path to install the software; then select OK.
4. When installation completes successfully, select OK.
Restart the system.
. on the diskette.
SETUP EXE
17
. file on the
README TXT
. utility.
RDISK EXE