Invalid Configuration Information For Slot Xx" Message Displays; Dma Bus Time-Out Message Displays; Video Errors; Video Displays During Boot Up, But Not When Windows Nt Starts - Intergraph InterServe 600 Series System Setup

"Invalid configuration information for SLOT XX" message displays

Reason
System is not properly configured to
recognize the new ISA option board.

DMA bus time-out message displays

Reason
Failure in DMA bus logic has occurred.

Video Errors

Video displays during boot up, but not when Windows NT starts

Reason
Resolution selected is not supported by the
installed monitor.
Improper video display driver is installed.

System powered on, but screen remains blank

Reason
Monitor not powered on.
Monitor power cord not connected.
Video cable not properly installed.
Solution
Run the System Configuration Utility and
set the board to its proper configuration
according to manufacturers instructions.
Solution
Call the Customer Response Center.
Solution
Reboot the server, using the VGA mode of
the operating system. Use Video
Configuration to select a supported
resolution. See Chapter 2.
Remove the video display driver and install
a valid driver. See Chapter 2.
Solution
Turn power on to monitor.
Connect the monitor power cord to AC
outlet and monitor.
Ensure the video cable is installed in
monitor and base unit.
39