Measurement Commands; Calculate:average:clear; Calculate<Chn>:Average<N>:Data - Fluke 1529 Chub-E4 User Manual

1529 Chub-E4 Thermometer Readout
User's Guide
8.4.1
8.4.1.1
8.4.1.2
88
<num> indicates numeric value is required.
<chn list> indicates a list of channel numbers is required.
<bool> indicates a Boolean value (0 or 1) is required. The mneumonics
OFF and ON are also accepted for 0 and 1, respectively.
<conv> indicates a conversion mnemoic is required.
<param> indicates a parameter name is required.
<seri> indicates a serial number is required.
<res> indicates a resistance value is required.
<volt> indicates a voltage value is required.
<unit> indicates a temperature unit is required.
<pass> indicates a password is required.
<port> indicates a port number is required.
<label> indicates an eight character label is required.
<year> indicates a four digit number is required.
<month> indicates a one or two digit number is required.
<day> indicates a one or two digit number is required.
<hour> indicates a one or two digit number is required.
<minute> indicates a one or two digit number is required.
<second> indicates a one or two digit number is required.
<baud> indicates a valid baud number is required.

Measurement Commands

The measurement commands are used to read information on the statistical cal-
culations and for reading the most recent measurement for a specified channel.
The measurement commands are not password protected.

CALCulate:AVERage:CLEar

Clears the statistical functions for all channels.
CALC:AVER:CLE
The *RST command clears the statistical functions.
CALCulate<chn>:AVERage<n>:DATA?
Returns the value of a statistical calculation for a given channel.
CALC3:AVER1:DATA?
0.017