Connecting To An External Device; Remote Connection ([Remote] Connector); Controlling External Head Amplifiers From The Dme64N/24N - Yamaha DME64N - Pro Audio Owner's Manual

Remote Connection ([REMOTE] Connector)

Connecting to an External Device

Remote Connection ([REMOTE] Connector)
The [REMOTE] connector of the DME64N/24N can be connected to remotely-controllable Yamaha AD8HR
or AD824 head amplifiers (pre-amps), digital mixers, or RS-232C compatible controllers (such as those from
AMX or Crestron). The [REMOTE] connector also transmits and receives MIDI messages.
Controlling external head amplifiers from the DME64N/24N
You can remotely control the AD8HR or AD824 head amplifier settings from DME Designer. Up to eight
AD8HR/AD824 head amplifiers can be connected.
When connecting an AD8HR or AD824 be sure to set the "Utility" screen "MISC" page (see manual page 49)
"Remote" parameter to "HA Control (RS422)". Also, do change to any other setting than "HA Control
(RS422)" while the unit is connected. Doing so can damage the unit.
When connecting to a combination of AD8HR and AD824 head amplifiers, be sure to place the AD8HR units
closest to the DME64N/24N in the chain, otherwise the AD8HR or AD824 unit(s) may not be properly rec-
ognized by the DME64N/24N.
Set to HA Control
(RS-422)
DME64N/24N
AD824
N OT E
Only control signals are transmitted and received via the REMOTE connection. Audio connections must be made separately.
28
DME64N/DME24N Owner's Manual
D-SUB 9-pin Cable (Interlink Crossover)
REMOTE
AD8HR
COM PC/RS-422 COM RS-422
AD824
HA REMOTE 1 HA REMOTE 2
COM PC/RS-422 COM RS-422
HA REMOTE 1 HA REMOTE 2
AD8HR
COM PC/RS-422
AD824