"Da Snap Ring Installation; "Ea H-L Shift Fork/H-L Clutch Sleeve Installation; "Fa Spacer Installation; "Ga Transfer Case Plate Installation - Mitsubishi V5A51 Manual

23E-15-6
Solder
E
Mitsubishi Motors Corporation
V5A51 -

"DA SNAP RING INSTALLATION

Select a proper snap ring so that the end play of the H-L
clutch hub will have the standard value, and install the snap
ring on the transfer drive shaft.
Standard value: 0 - 0.08 mm
"EA H-L SHIFT FORK / H-L CLUTCH SLEEVE
Apply grease to the H-L shift fork shaft inserting portion, and
install the H-L shift fork and H-L clutch sleeve in combined
state in the transfer case.
Specified grease:

"FA SPACER INSTALLATION

1. Put pieces of solder (approx. 10 mm long and 1.6 mm
2. Install the countershaft gear and transfer case plate and
3. If the pieces of solder are not crushed, put thicker pieces
4. Measure the thickness of the crushed pieces of solder

"GA TRANSFER CASE PLATE INSTALLATION

1. Apply grease to the illustrated position of the high/low
Mar. 2000
Transfer
INSTALLATION
MITSUBISHI genuine grease part No. 0101011 or
equivalent
in diameter) at the illustrated positions of the transfer
case.
tighten the bolts to the specified torque.
of solder and perform Steps 1 and 2.
with a micrometer, and select a spacer of proper thickness
so that the end play will have the standard value.
Standard value: 0 - 0.15 mm
shift rail inserting portion of the transfer case plate.
Specified grease:
MITSUBISHI genuine grease part No. 0101011 or
equivalent
PWEE8920-I Added