Mitsubishi V5A51 Manual page 58

23E-5-32
Outer springs
4 3
Inner springs
4 3 2
6
Oil seals
Oil strainer
E
Mitsubishi Motors Corporation
V5A51 -
52. Install a new seal ring onto each accumulator piston.
53. Install each accumulator piston and spring, then install
2 1, 5, 6
1
5
54. Install the oil strainer and two new oil seals. Install the
Mar. 2000
Transmission
accumulator cover with O-ring and snap ring.
NOTE
(1) Install the accumulator pistons to the original positions
following the identification tags attached when they
were removed.
(2) The springs are identified by paint application position
as shown below. Assemble following this table.
No. Name
1 For overdrive
clutch
2 For second
brake
3 For
low/reverse
brake
4 For underdrive
clutch
5 For reduction
brake
6 For direct
clutch
oil seals so that the notched section is oriented as shown
in the illustration.
Caution
D Take care to the installation direction of the oil
seal.
PWEE8920-I
Identification paint
application position
None
Inner Applied on all surfaces
including both ends
Outer Applied on half of surface
including both ends
Inner Applied on half of surface
including both ends
Outer Applied on entire surface
of one side
Inner Applied on half of surface
including both ends
Outer Applied on half of surface
including both ends
None
None
Added