Mitsubishi V5A51 Manual page 56

23E-5-30
Thrust bearing No.2
MD998316
E
Mitsubishi Motors Corporation
V5A51 -
41. Apply Vaseline or petrolatum jelly on the thrust race No.1,
Thrust race
No.1
42. Install the special tool at the position shown in the
MD998412
43. Tighten the ten oil pump mounting bolts to the specified
44. Using the special tool, set a dial gauge as shown in the
45. Measure the end play again, and confirm that it is within
46. Install the converter housing.
47. Tighten the eight converter housing mounting bolts to
Mar. 2000
Transmission
Caution
D Take care not to mistake the thrust bearing No.2
mounting direction.
and then install on the oil pump.
illustration, and using this as a guide, install the oil pump
and gasket.
Caution
D Never reuse the gasket.
torque.
illustration. Measure the end play of the input shaft, and
replace the thrust race installed in step 41 with a suitable
one so that the end play may meet the standard value.
Then, reassemble.
Standard value: 0.25 - 0.81 mm
the standard value.
the specified torque.
PWEE8920-I Added