Table of Contents
Advertisement
23E-5-24
Center support
Direct planetary
carrier
MB991603
Standard value
Center support
Snap ring
Low/reverse
brake piston
MB991632
MD998913
MB991632
E
Mitsubishi Motors Corporation
V5A51 -
24. Using the following steps, select a snap ring for adjusting
Snap ring
Snap ring
End play
Mar. 2000
Transmission
(2) Alternately push in the direct planetary carrier and
center support, and measure the end play of the
center support.
NOTE
Be sure to push the direct planetary carrier in fully
until the center support contacts the snap ring.
(3) Replace the snap ring for fixing the center support
installed in step 23 (1) with a suitable one so that
the end play of the center support is at the standard
value. Then, reassemble.
Standard value: 0 - 0.16 mm
(4) Measure the end play again, and confirm that it is
within the standard value.
the brake reaction plate end play and second brake end
play, and a pressure plate for adjusting the low/reverse
brake end play.
(1) Install the wave spring onto the low/reverse brake
piston.
(2) Install the special tool in the position shown in the
illustration instead of the pressure plate for the
low/reverse brake. Install the brake discs, brake plates
and snap ring.
(3) Install the reaction plate and snap ring that was used.
Caution
D
Take care to the assembly direction of the
reaction plate.
(4) Install a dial gauge onto special tool (MD998913)
so that the tool end contacts the brake reaction plate.
Measure the end play by moving special tool
(MB991632).
(5) Replace the snap ring installed in step 24 (3) with
a suitable one so that the end play may fall within
the standard value. Then, reassemble.
Standard value: 0 - 0.16 mm
(6) Measure the end play again, and confirm that it is
within the standard value.
PWEE8920-I
Added
Hide quick links:
Advertisement
Table of Contents
