Mitsubishi V5A51 Manual page 47

MB991633
(Socket)
MB991633
(Wrench)
Snap ring
Seal rings (large)
Thrust bearing No.12
Direct
planetary
carrier
E
Mitsubishi Motors Corporation
V5A51 -
13. Install a new O-ring on the reduction brake piston cover,
Reduction brake
piston cover
14. Install new seal rings (two large pieces) onto the front
Seal
rings
(small)
15. Insert the direct planetary carrier into the output shaft
16. Apply Vaseline or petrolatum jelly on the thrust bearing
Mar. 2000
Transmission
(4) Tighten the reduction brake piston nut to the specified
torque of 19 ± 3 Nm using the special tool (Wrench)
while fixing the special tool (Socket) so as not to
rotate.
and then install the cover and the snap ring on the
transmission case.
end of the direct planetary carrier, and new seal rings
(two small pieces) onto the shaft of the direct planetary
carrier.
support.
No.12, and then install on the front end of the direct
planetary carrier.
Caution
D Take care not to mistake the thrust bearing No.12
mounting direction.
PWEE8920-I
23E-5-21
Added