Mitsubishi V5A51 Manual page 46

23E-5-20
Snap ring
Reduction brake piston
MB991693
MB991633
(Socket)
E
Mitsubishi Motors Corporation
V5A51 -
10. Press the reduction brake piston into the transmission
11. Tighten the reduction brake piston adjusting rod manually
12 Adjust the reduction brake piston by the following
Mar. 2000
Transmission
case, and then install the snap ring.
NOTE
Set the open of the snap ring at indicated location.
to the full.
procedure.
(1) Mount the special tool so that the reduction brake
piston does not rotate.
(2) Mount the torque wrench to the special tool (Socket),
and after repeating tightening and turning back with
a torque of 10 Nm twice, tighten the reduction brake
piston adjusting rod to the specified torque of 5 Nm.
Then turn the reduction brake piston adjusting rod
1 3
5 / to 5 / turns back.
2 4
(3) Remove the special tool and tighten the reduction
brake piston nut manually.
PWEE8920-I Added