Setting Unit For Use - A&D SW-D Setup Instructions

8.2. Setting unit for use

1． Refer to "7.1. Items of the calibration", to enter the
calibration mode. The indicator displays "
2. Press the MODE key three times to display "
3. Press the TARE key to display the setting item.
4. To proceed without storing this setting item, press the
ZERO key.
After displaying "
(Display example: "
5. Select the unit to be used, using the following keys.
UNITS
PRINT
About the unit setting mode
Each of the display digits are assigned to a unit setting.
(The setting at the first and fourth digit is not available.)
Display
assignment
Unit
-The unit during selection is indicated.
-With each digit, if setting to "0", its unit is not available, and
if setting to "1", its unit is available.
(Only when set to "1", is a unit available.)
Even if a unit is stored, availability for use depends on the
weighing capacity and resolution.
Example) When setting to "
and "kg" are available as units.
6. Press the TARE
end
" ", the indicator displays "
If you want to proceed without storing the setting of the unit
setting mode, press the ZERO key. After displaying "
the setting is complete.
Unit
", proceed to the unit setting mode.
1110000
pcs")
Select the unit (Shift the blinking unit to the
right)
Set whether the selected unit is available (0)
or not available (1). (Change the number of the
blinking digit to "0" or "1".)
7 6 5
pcs g kg
1010000
key to store the setting. After displaying
Cf
", and the setting is complete.
Cal5et
".
Cf
".
4 3 2
Set
oz lb
disabled
pcs", only "pcs"
17
Press
three times
Press
Press
Press
1
Set
disabled
Press
Cf
",