Setting A Unit Price - A&D SF-6KB Instruction Manual

SF/SG Series Operating Instructions
Note about keypad tare entry:
• When a TARE weight has been set, an error message
enter a lower value than the TARE weight.
• If you enter a TARE weight greater than the weighing capacity of the scale, an error message
will appear as shown below.
WEIGHT
0.000
NET ZERO
• To release the error shown above, press
• Any previous TARE entries will be cancelled when
• To cancel a TARE weight that has been entered, remove any weight from the weighing pan
and press
T
TARE

4. Setting a Unit Price

Step 1: Enter a unit price using the numerical keypad. Up to 6 digits may be entered.
Example: Enter a unit price of $5.50
NET ZERO
Step 2: Unit price entry must be completed within 3 seconds. Any delay beyond 3 seconds
will require the unit price to be re-entered.
MODE
.
WEIGHT
0.000
Err tr
" "
will appear as shown below, if you
UNIT PRICE
------
to return to the weighing mode.
0
is pressed.
ZERO
UNIT PRICE
5.50
Err tr
" "
PRICE
Err tr
PRICE
0.00
7