Cf Function List - A&D SW-D Setup Instructions

8.3. CF Function list

Item
Used internally
Cf 1
Used internally
Cf 2
Zero tracking
Cf 3
Power on zero
range
Cf 4
Calculation of tare
Cf 5
Stable indicator of
during tare
Cf 6
Tare clear by
zero operation
Cf 7
Used internally
Cf 8
Minus and
printing limit
Cf 9
Auto tare function
Cf10
Stable detection
range
Cf11
Used internally
Cf12
Note: About minus and printing limit setting ("
When setting "
When the total weight is -19d or less, the indicator displays "
(*d = minimum division)
When the total weight is minus, the indicator does not perform the printing.
Parameter
3
Not available for setting change
0
Not available for setting change
Not available for setting of function
0
"trc" (It is fixed to "trc 1")
1
Available for setting of function "trc"
0
None
1
±10% of weighing capacity
2
±50% of weighing capacity
3
±100% of weighing capacity
0
Tare by displayed division
1
Tare by internal count
During tare, stable indicator has no
0
function
1
During tare, stable indicator turns on
0
Tare is not cleared by zero operation
1
Tare is cleared by zero operation
3
Not available for setting change
0
Non-limit
1
Limit has function
0
No auto tare function
1
Auto tare function
Not available for setting of function
0
"5t-b" (It is fixed to "5t-b 0")
1
Available for setting of function "5t-b"
0
Not available for setting change
Factory setting
Cf 9 1
" to " ", the indicator has the following limit.
Description
Cf 9
")
18
When "Cf 3 0", "trc"
has no function.
Calibration zero
reference
Refer to below note.
When "Cf10 0", "at"
"at-t" "at-f" has no
function.
When "Cf11 0", "5t-
b" has no function.
-e
".