Gravity Acceleration Correction - A&D SW-D Setup Instructions

7.3. Gravity acceleration correction

When the scale is first used or has been moved to another location, it should be
calibrated using a calibration weight.
But if a calibration weight is not available, the gravity acceleration correction will
compensate the scale. Change the gravity acceleration value stored in the scale to the
value of the area where the scale will be used. Refer to the gravity acceleration map at
the end of this manual.
Note: Gravity acceleration correction is not required when the scale will be
calibrated using a calibration weight at the place where it is to be used.
1. Refer to "7.1. Items of the calibration mode", to enter the
calibration mode. The indicator displays "
2. Press the
acceleration value).
3. Press the TARE key to enter the gravity acceleration
value setting mode.
4. Change the displayed value using the following keys.
UNITS
PRINT
5. Press the TARE key. The setting value is stored and
end
" " is displayed. After displaying "
acceleration value), the setting is complete.
6. When calibration using a calibration weight is to be
performed, go to step 3 of "7.4. Calibration using a
weight".
To finish the setting procedure, press the
the CAL switch. The indicator turns the power off.
UNITS key to display "
To shift the blinking digit to the right.
To increase the value of the blinking digit
by one.
Cal5et
".
g 9. 7 985
" (gravity
g 9. 7 985
" (gravity
ZERO1 key or
13
Press
Press
Press
Press