A&D SW-D Setup Instructions page 13

The chart below shows the relation between each item and the key operation in the
calibration mode.
Press the (CAL)
switch
Press the UNITS key to select an item and press the TARE key to execute it.
To exit from the calibration mode, press the
indicator turns the power off. (Or press the ON/OFF key to turn the power off.)
Weighing mode
Press
Power OFF
Setting of the weighing
capacity, minimum division,
and decimal point
Gravity acceleration
correction
Calibration using a weight
Setting of the CF function
or
ZERO1 key or the CAL switch. The
11