Performing Communication By Using The Smart Media - JUKI ACF-172-1790 Instruction Manual

3-1-2 Performing communication by using the smart media

[ Setting procedure ]
hen the upper side cover located on the side of
the operation panel is opened, there is the
inserting opening for smart media card. Put
the contact part of the card to the front side
and insert it into the opening
① The smart media card stops once in the protruding state by approximately 10 mm while
inserting the card. Further, apply force to insert the card and ease up the force when it is
reached to the end. Setting is completed when the card has returned by approximately 1 mm.
② After completion of setting of the card, close the smart media cover. By closing the cover, it is
possible to perform communication.
If the smart media card and the cover come in contact with each other and the cover is not
closed, check the following matters.
・ Check that the inserting is stopped in the state that the card protrudes by approximately 10
mm.
・ Check that the contact part of the card is put downward and inserted.
・ Check that the smart media card other than 3.3V voltage type is used.
89