Server Blade To Enclosure Interface; Port Locations On The Rear Of The Server Blade Enclosure; Server Blade To Enclosure Interconnect Mapping - HP Integrity BL870c User's & Service Manual

Server Blade to Enclosure Interface

This section shows the location of the RJ-45 LAN ports on the back of the server blade enclosure,
and how they correspond with the Network Interface Controller (NIC) LEDs on the front of the
server blade.

Port Locations on the Rear of the Server Blade Enclosure

LAN port mapping depends on the type of I/O card that is installed into the server blade.
shows some of the modules available for the c7000 enclosure.
NOTE: This picture is used only to show the different modules, not where the modules should be
installed.
Figure 32 Interconnect Modules on the Rear of the Server Blade Enclosure

Server Blade to Enclosure Interconnect Mapping

Table 7 shows how the HP Integrity BL870c server blade slots interconnect with the slots on the
c7000 enclosure.
Table 7 Server Blade to Enclosure Interconnect Mapping
Server Blade to c7000 Enclosure Mapping
Server Blade
NIC outputs or mezzanine slots
Ethernet NICs
Mezzanine Slot 1
54 Installing the Server Blade Into the Enclosure
Enclosure
Interconnect Slots
Slots 1 and 2
Slots 3 and 4
Figure 32