Replacing A Disk Drive Blank; Preparing The Server Blade For Servicing; Powering Off The Server Blade - HP Integrity BL870c User's & Service Manual

Figure 40 Removing a Disk Drive Blank

Replacing a Disk Drive Blank

To replace the disk drive blank, slide the blank into the bay until it locks into place. The disk drive
blank is keyed to fit only one way.

Preparing the Server Blade for Servicing

To service an internal server blade component, power down the server blade and remove it from
the server blade enclosure.
CAUTION:
grounded before beginning an installation procedure. For more information, see the
Information" (page

Powering Off the Server Blade

The front panel power switch, or the Virtual Power Button, do not completely shut the power off in
the server blade. This toggles between on and standby modes, rather than on and off. The standby
position removes power from most components and drives, but portions of the power supply and
some internal circuitry remain active.
WARNING!
contact with electrical or electronic components, ensure that power is removed or safety precautions
are followed to prevent electric shock and equipment damage. Observe all WARNING and CAUTION
labels on equipment.
To service internal server blade components:
1. Identify the proper server blade in the server blade enclosure.
The enclosure slots are numbered Bay 1 one through Bay 16 from left to right.
Electrostatic discharge can damage electronic components. Ensure you are properly
26).
Before proceeding with maintenance or service on a server that requires physical
Preparing the Server Blade for Servicing
"Safety
1 13