Sysmode; Syntax; Parameters; Operation - HP Integrity BL870c User's & Service Manual

Example 22 pdt command
Shell> pdt
PDT Information
Number of total entries in PDT:
Number of used entries in PDT:
Number of free entries in PDT:
Number of single-bit entries in PDT:
Number of multi-bit entries in PDT:
Address of first multi-bit error:
Example 23 pdt clear command
Shell> pdt clear
Are you sure you want to clear the PDT? [y/N] y
Shell>
Shell> pdt
PDT Information
Number of total entries in PDT:
Number of used entries in PDT:
Number of free entries in PDT:
Number of single-bit entries in PDT:
Number of multi-bit entries in PDT:
Address of first multi-bit error: 0x0000000000000000

sysmode

Display or modify the system mode.

Syntax

sysmode <normal | admin| service>

Parameters

<normal>
<admin>
<service>

Operation

If specified alone, sysmode displays the system mode. If a mode is specified as a parameter, then
the system mode is changed. This new mode takes effect immediately. The system mode is retained
on successive boots. Interaction with sysmode in a variety of scenarios is outlined below.
Last Clear time: PDT has not been cleared
Last Clear time: 10/21/01
sets system mode to normal
sets system mode to admin
sets system mode to service
50
0
50
0
0
x0000000000000000
5:00p
50
0
50
0
0
EFI/POSSE Commands 163