HP Integrity BL870c User's & Service Manual page 141

1. Install the system board into the server by lining up the keyways on the system board with the
guide keys on the server blade chassis. For the guide key locations, see
Figure 66 Guide Keys on the System Board
2. Shuttle the system board toward the front of the server blade until it clicks into place.
3. Tighten the four captive thumbscrews on the system board to attach the system board to the
server blade chassis.
For the thumbscrew locations, see
4. Install the TPM (if necessary).
See "Replacing the TPM" (page
5. Install the air baffles.
6. Install the front panel.
See "Replacing the Front Panel" (page
7. Install the SAS backplane and cable.
See "Replacing the SAS Backplane" (page
8. Install the processor MVR cable by pushing it into the connector on the system board.
9. Install the processors onto the system board.
See "Replacing a Processor" (page
10. Install the mezzanine card or cards.
See "Replacing a Mezzanine Card" (page
1 1. Replace the right access panel.
12. Install the SAS disk drives or disk drive blanks.
See "Replacing a SAS Disk Drive" (page
13. Turn the server blade over to access the left side of the server blade.
14. Remove the left access panel.
See "Removing the Left Access Panel" (page
Figure 65 (page 140).
137).
132).
130).
127).
135).
"Replacing the Right Access Panel" (page
112).
118).
Removing and Replacing the System Board
Figure 66.
117).
141