Certificate Assignment - Psion Teklogix PX750 User Manual

Chapter 5: Configuration

Certificate Assignment

Add Key
Only existing trigger sources are shown in the Source combo-box. To add a new source to
this list, tap on the Add Key button. A dialog will pop up and allow you to select the key-
board key to use as a trigger source.
Trigger-Press Type
You can enable either an Up/Down or Double Click response to a trigger press. Normally,
when a trigger (keyboard key, etc.) is pressed and released, a "trigger down" event is sent to
the "owner"– that is, the application receiving the trigger press information—followed by a
"trigger up". If Double Click is chosen in this menu, when the trigger is pressed, released,
and then pressed again, a "double-click" event will have occurred. If a mapping with the
type Up/Down has also been configured for the same source, it will only receive the first set
of trigger events.
Module Trigger
This identifies the driver or application receiving the trigger presses.
Show All Modules
By default, inactive owners are not shown. By checking this checkbox, all owners, both
active and inactive, are displayed.
5.5.7

Certificate Assignment

• In the Control Panel, choose the Certificate icon.
Psion Teklogix NEO Hand-Held Computer User Manual 101