Euphonix Max Air Mixing Console Operation Manual
7.5.1
Solo Mode
The three solo modes can be selected by pressing their respective keys (1 in Figure 7-
18) in the Solo Setup popup. Selecting one mode deselects the last mode.
AFL (After-Fader Listen): Signal is post-fader and pan (stereo)
PFL (Pre-Fader Listen): Signal is pre-fader in mono
Solo-In-Place: Allows solo channels through to the main busses. Mutes all channels not
soloed but not channels designated Solo-Safe (page 141). Solo-In-Place allows monitor-
ing soloed channels with panning and effects if the effects returns have been designated
Solo-Safe. Because this is a destructive solo mode, we do not recommend Solo-In-
Place for live broadcast or for recording.
7.5.2
Solo Level
The Solo Level fader (3) controls the solo level (AFL and PFL modes) sent to the
speakers or the Solo Output in the Patch View. This controls the same level as the Level
knob in Solo area of the center section (Figure 7-17).
7.5.3
Clear Solo
Touch the Clear All Solos (5) button in the Solo Setup popup to clear all solos on all
channels. This can also be done by pressing the Level knob or the Clear Solo key in
the Solo area in the center section (Figure 7-17).
7.5.4
Solo Switch Mode
There are three options available (2) in the Solo Setup popup that control the Solo key
on a strip:
•
Intercancel: Pressing each new Solo key clears the last solo channel and acti-
vates the new one.
•
Momentary: The Solo key must be held down but multiple channels can be ac-
tive at a time.
•
Sum: Multiple channels can be soloed by pressing additional Solo keys; they
must be explicitly cleared.
140
Center Section