Euphonix Max Air Operation Manual page 34

Euphonix Max Air Mixing Console Operation Manual
7. Touch Set Format to make busses 1 and 2 into a stereo pair assigned to Main
section A.
The Main Section Master Level control can be mapped to the Soft Knobs just
below the screen by pressing the Main Masters key just below the screen in
the Soft Knobs section. This allows the main section to be switched on/off and
level trimmed.
8. Assign Main busses 3 and 4 as Stereo to main section B, 5 and 6 to main section
C, 7 and 8 to main section D, 9 and 10 to main section E.
9. Since main section E is the main stereo program bus, press the E button on the
left and name it Prog in the keyboard popup. Name the other main sections
SubA, SubB, etc.
Setup Four Output Faders for Main Sections A–D
Create four stereo MF Masters to act as Subgroup Master Channels fed from Main sec-
tions A–D. This allows fader level control and full output processing.
1. Select Channels from the Main Menu buttons.
2. Select the MF Masters tab.
3. Since MF Masters 1–32 are already used, select the Masters 33–40 tab beneath
the bank of channel buttons.
4. Page through the channels to show Page 7 of 7.
This brings up bonus channels 97–106. These extra channels are very useful as
processing channels for group masters. Max Air only allows the first 96 chan-
nels to be assigned to Strips, so these bonus channels are always available for
subgroup masters.
5. Assign channels 97 and 98 as a stereo pair to MF Master 33, channels 99 and
100 to MF Master 34, channels 101 and 102 to MF Master 35 and channels 103
and 104 to MF Master 36.
6. Touch the four MF Masters buttons (M33, M34, etc.) to name them in the key-
board popup (SubA, SubB, SubC and SubD).
Patch the Main section outputs A–D into these channels.
7. Select Patch from the Main Menu buttons.
8. Select the Console I/O tab.
9. Select the Main Busses gray button on the left and the 1–16 tab to show the
first 16 Main busses.
10. Touch and drag through the first eight bus outputs in the green Out column to
select Main Bus Outputs 1–8 (used by Main sections A–D, labelled Sub A, etc.).
34
Quickstart to Common Tasks