Solo Linking; Physical Connection Between Systems - Euphonix System 5 Setup Manual

Post and film

Hide thumbs Also See for System 5:

Table of Contents

Euphonix System 5 Post and Film Setup Guide

Solo Linking

NOTE: Problems may occur if the Solo Linking service is running when eMix is in-

stalled. To avoid this, open the MOConfig.exe application and click Stop to

stop the service before installing newer software.

In a two-operator system, a single Cat5 cross-over cable connects the two system PCs

using the spare network adaptor ports.

In a three-operator system, the three System PCs are connected via a central ethernet

switch.

NOTE: The Solo Linking service requires the Windows user account to have a non-

blank password. Before continuing to Network Settings, make sure your Win-

dows account has a non-blank password: Open the Windows Control Panel

(Start->Settings->Control Panel), double-click on the User Accounts ap-

plet, and click the Reset Password button at the bottom-right of the dialog

(make sure your user account is highlighted in that window). Enter a pass-

word and press OK to close the dialog.

Figure 2 Crossover Network Cable

Table of Contents

Do you have a question about the System 5 and is the answer not in the manual?