Copying Memory Contents - Icom IC-E7 Instruction Manual

6
MEMORY/CALL CHANNELS

■ Copying memory contents

This function transfers a memory channel's contents to a VFO
(or another memory channel). This is useful when searching
for signals around a memory channel frequency and for re-
calling the offset frequency, subaudible tone frequency etc.
D Memory➪VFO
q Select the memory channel to be copied.
➥ Push [V/M] (
SKIP
mode, then rotate [DIAL] to select the desired memory
channel.
• Select the bank channel with [BAND] (
if desired.
wPush and hold [V/M] (
memory write mode.
• 1 short and 1 long beep sound.
• " " indicator and memory channel number blink.
e Rotate [DIAL] to select "VF."
r Push and hold [V/M] (
• VFO mode is selected automatically.
[EXAMPLE]: Copying channel 20 to 51.
Select memory channel
S.MW
WFMAM - DUP T SQL DTCS ATT
VOL PRIO P SKIP MR
LOW 1 5 9
29
) momentarily to select memory
• .
S MW
• ) and [DIAL],
TS LOCK
) for 1 sec. to enter select
• .
SKIP S MW
) for 1 sec. again.
• .
SKIP S MW
Push for 1 sec.
S.MW
WFMAM - DUP T SQL DTCS ATT
VOL PRIO P SKIP MR
LOW 1 5 9
Pushing and holding [V/M] (
step w, can also copies the memory contents to VFO. In
this case, steps e and r are not necessary.
D Memory➪memory
q Select the memory channel to be transferred.
➥ Push [V/M] (
tate [DIAL] to select the desired memory channel.
wPush and hold [V/M] (
memory write mode.
• 1 short and 1 long beep sound.
• " " indicator and memory channel number blink.
• Do not hold [V/M] (
memory contents will be copied to VFO.
e Rotate [DIAL] to select the target memory channel.
rPush and hold [V/M] (
fer.
Rotate
WFMAM - DUP T SQL DTCS ATT WFMAM - DUP
VOL PRIO P SKIP MR VOL PRIO P SKIP
LOW 1 5 9 LOW
1
• . ) for 2 sec. at the
SKIP S MW
) to select memory mode, then ro-
• .
SKIP S MW
) for 1 sec. to enter select
• .
SKIP S MW
) for more than 1 sec. otherwise the
• .
SKIP S MW
) for 1 sec. again to trans-
• .
SKIP S MW
Push for 1 sec.
S.MW
T SQL DTCS ATT WFMAM - DUP T SQL
MR VOL PRIO P SKIP
LOW 1 5
5 9
DTCS ATT
MR
9