1750 Hz Tone; Repeater Operation - Icom IC-E7 Instruction Manual

5

REPEATER OPERATION

■ 1750 Hz tone

Some European repeaters require a 1750 Hz tone burst to be
accessed. For such European repeaters, perform the follow-
ing.
q Set the receive frequency (repeater output frequency).
wSet the shift direction of the transmit frequency. (–DUP or
+DUP; see p. 19 for details.)
• "–DUP" or "+DUP" indicates a minus or plus offset of the transmit
frequency, respectively.
eWhile pushing and holding
[PTT], push and
) for 1 to 2
[SQL] ( •
ATT SET
sec. to transmit a 1750 Hz
tone burst signal.
• The displayed frequency auto-
matically changes to the trans-
mit frequency (repeater input
frequency).
• If "OFF" appears, check the off-
set frequency (see p. 20 for de-
tails) or shift direction (p.19).
rPush and hold [PTT] to transmit.
t Release [PTT] to receive.
yPush and hold [SQL] (
input frequency.
23
hold
SCAN
S.MW
SET
SET
) to monitor the repeater
•
ATT SET
✔ CONVENIENT!
qSet the receive frequency, or shift direction (see p.19 for
details.).
wPush [PTT] briefly, then push
and hold [PTT] again for 1 to
2 sec. to transmit a 1750 Hz
tone burst signal.
• The displayed frequency auto-
matically changes to the trans-
mit frequency (repeater input
frequency).
• If "OFF" appears, check the off-
set frequency (see p. 20 for de-
tails) or shift direction (p.19).
ePush and hold [PTT] to
transmit.
r Release [PTT] to receive.
tPush and hold [SQL] (
ATT
input frequency.
then
SCAN
S.MW
SET
) to monitor the repeater
•
SET