[Vol] Function Assignment; Lockout Function - Icom ic-80fx Instruction Manual

4
BASIC OPERATION

■ [VOL] function assignment

[VOL] can be used as a channel selector instead of [ ] and
[ ], to suit your preference. However, when [VOL] functions as
a channel selector, [ ] and [ ] function as volume controls.
q While holding down [
enter the Initial Set mode.
w Push [ ] or [ ] to select the dial assignment item. (tOP)
e Rotate [VOL] to select an option.
[VOL]
r Push [# ENT](MN.W) to exit the Initial Set mode.
[VOL] and [ ]/[ ] function as described below, depend-
ing on the option.
Option [VOL]
tOP.VO Volume control
tOP.di Channel selector
17
] and [ ], turn ON the power to
[VOL] functions as the volume control.
[VOL] functions as the channel selector.
[ ]/[ ]
Channel selector
Volume control

■ Lockout function

The Lockout function helps prevent interference to other sta-
tions by inhibiting transmitting when the channel is busy.
The function is set in the Initial Set mode.
q While holding down [
] and [
enter the Initial Set mode.
w Push [ ] or [ ] to select the lockout item. (RLO)
e Rotate [VOL] to select an option of the Lockout function.
• "RLO.OF" : Allows transmitting, even if the channel is busy.
• "RLO.RP" : Inhibits transmitting when the channel is busy, ex-
cept while receiving a signal that includes a match-
ing subaudible tone.
• "RLO.bU" : Inhibits transmitting when the channel is busy.
r Push [# ENT](MN.W) to exit the Initial Set mode.
[VOL]
], turn ON the power to
The RP Lockout function is ON.