Skip Channel Setting; Scan Resume Condition - Icom IC-W32A Instruction Manual

8
SCAN OPERATION

Skip channel setting

Memory channels can be set to be skipped for memory skip
scan. This is useful to speedup the memory skip scan inter-
val.
MAIN
q Select the memory channel to be programmed as a skip
channel:
Push [MAIN] to select the desired band.
Push [MR] to select memory mode.
Rotate [DIAL] or push 2 digit keys to select the memory
channel.
w Push [
SKIP] for 2 sec. to set the memory channel as a
(MR)
skip channel.
• " " appears.
S
e Repeat step w to cancel a skip channel.
• " " disappears.
S
30
SKIP
MR
MAIN
Push for
S
2 sec.
Indicates the channel is set
as a skip channel.

Scan resume condition

The resume condition can be selected as a pause or timer
scan for each band (VHF VFO and memory channels, UHF
VFO and memory channels, avionics* band).
Scan set mode
USING
SETTING THE SCAN RESUME CONDITION
(Following displays show the 144 MHz band full/programmed scan)
15 sec. timer for resume
condition
q Turn power ON while pushing [
scan set mode.
w Push [
J] or [ K] several times to select the de-
(H/L) (TONE)
sired band to be set.
• Avionics*/144/430(440) VFO, VHF/UHF memories are available.
e Rotate [DIAL] to select the desired resume condition.
• "t-15": scan pauses for 15 sec. on a received signal.
• "t-10": scan pauses for 10 sec. on a received signal.
• "t-05": scan pauses for 5 sec. on a received signal.
• "P-02": scan pauses on a received signal until it disappears.
r Turn power OFF to exit scan set mode.
Pauses until the signal
disappears
SCAN] to enter
(MAIN)
* U.S.A. and Asia versions only.