Memory Names - Icom IC-W32A Instruction Manual

6
MEMORY/CALL PROGRAMMING

Memory names

Memory channels can be programmed with names of up to 8
characters in length.
Names cannot be programmed into the call channel.
D Frequency name
To toggle between frequency indication and memory name
indication:
Push [M•N] to toggle between frequency and name indi-
cations.
• "NO NAME" appears when a memory channel has not been
programmed with a name.
MAIN
Frequency indication
The following characters can be used in names:
0 to 9, A to Z (capitals), (space), , , M, +, –, " " /, " "
and =.
NOTE: While using the monitor function, the frequency
readout shows the transmit frequency even when memory
name indication is selected.
24
M•N
MAIN
Name indication
"H" indicates 'High' band (UHF)
D Programming memory names
q Assign the main band to the desired display with [MAIN].
w Select the memory channel to be programmed:
Push [MR] to select memory mode.
Rotate [DIAL] or push 2 digit keys to select the memory
channel (only programmed memories can be selected).
e Push [M•N] to select memory name indication.
r Push [
MN•W] for 2 sec. to enter memory name writ-
(M•N)
ing mode.
• The first character of the name
flashes.
t Enter the desired name via the
keypad or [DIAL].
• Push the appropriate keys to input
the desired characters using the
same convention as for telephones.
• To erase a character, overwrite with
a "space" using the [ Symbol] key.
(0)
• To move the cursor forwards or back-
wards, use the [ ≈] or [
(M•N) (#)
y Push [
CLR] to input the set
(VFO)
name.
• Flashing stops.
• Eight characters is the maximum for
a name.
MAIN
MAIN
MAIN
Ω] key.
MAIN