Transmitting A Dtmf Code; Dtmf Memory; Dtmf Transmission Speed - Icom IC-W32A Instruction Manual

Transmitting a DTMF code

D Using a DTMF memory channel
q Push [
DTMF•M] for 2 sec. to enter DTMF memory mode.
(•)
w Rotate either band's [DIAL] to select the desired channel.
e Push [
CLR] again to exit DTMF memory mode.
(VFO)
r While pushing [PTT], push [
the selected DTMF code.
NOTE: Push [
(MAIN)(SCAN)
mode to monitor a DTMF channel without transmitting it.
DTMF] to transmit
(MAIN)(SCAN)
DTMF] while in DTMF memory

DTMF transmission speed

When slow DTMF transmission speeds are required (as for
some repeaters), the transceiver's rate of DTMF transmission
can be adjusted.
Initial set mode
USING
SETTING THE DTMF TRANSMISSION SPEED
Fastest (100 msec.
intervals)
q Turn power ON while pushing [
set mode.
w Push [
J] or [
(H/L)(SET) (TONE)
appears as shown above.
e Rotate [DIAL] to select the DTMF transmission speed.
r Turn power OFF to exit initial set mode.
7

DTMF MEMORY

Slowest (500 msec.
intervals)
SET] to enter initial
(H/L)
K] several times until "DT"
27