Memory/Call Programming; General; Programming During Selection - Icom IC-W32A Instruction Manual

6

MEMORY/CALL PROGRAMMING

General

The transceiver has 100 memory channels (plus 5 pairs of
scan edge channels) and 1 call channel on each band for
storage of often-used frequencies.
Avionics band frequencies are stored in the VHF memory
channels (U.S.A. and Asia versions only).
D Memory/call channel contents
The following information can be programmed into memory/
call channels:
• Operating frequency
• 8-digit memory name*
• Duplex direction (DUP or – DUP) with an offset frequency
(pgs. 19, 20)
• Subaudible tone encoder or tone squelch ON/OFF (pgs. 19,
32)
• Subaudible tone and tone squelch frequencies (pgs. 20, 32)
• Skip information*
1
* Except for call channels.
2
* Except for the scan edge memory channels.
22
1
2
(p. 30)

Programming during selection

q Assign the main band to the desired display with [MAIN].
w Select VFO mode with [VFO].
e Set the desired frequency:
Set the frequency using the keypad or [DIAL].
Set other data (e.g. offset frequency, duplex direction,
subaudible tone frequency, etc.), if required.
r Push [S.MW] momentarily to indicate memory channels.
• Do not hold [S.MW] for more than 0.5 sec., otherwise the mem-
ory channel will overwrite the displayed number.
t Rotate [DIAL] to select the desired channel.
• Call channel (CAL) and scan edge channels (1A–5B), as well as
regular memory channels, can be programmed in this way.
y Push [
MW] for 2 sec. to program.
(S.MW)
[EXAMPLE]: Memory programming of ch 40 during selection.
Set frequency and other data.
MAIN
momentarily
T SQL
DUP
S.MW MAIN