Programming After Selection; Memory Edit (Transferring) - Icom IC-W32A Instruction Manual

Programming after selection

q Assign the main band to the desired display with [MAIN].
w Select the memory channel to be programmed.
Push [MR] to select memory mode.
Rotate [DIAL] or push 2 digit keys to select the memory
channel (only programmed memories can be selected).
e Set the desired frequency in VFO mode:
Push [VFO] to select VFO mode.
Set the desired frequency using the keypad or [DIAL].
Set other data (e.g. offset frequency, duplex direction,
subaudible tone frequency, etc.), if required.
r Push [
MW] for 2 sec. to program.
(S.MW)
• If beep tones are turned ON, 3 beeps alert you that the VFO con-
tents, including duplex information, subaudible tone frequency,
etc., are programmed.
NOTE: Call channels cannot be programmed in this way.
MAIN
for 2 sec.
S.MW MAIN
T SQL
DUP
MEMORY/CALL PROGRAMMING
Memory edit
Memory (call) channel contents can be moved to VFO or to
another memory.
D Memory/call VFO
q Assign the main band to the desired display with [MAIN].
w Select the memory (call) channel to be transferred:
Push [MR] (or [CALL]) to select memory (call) mode.
Rotate [DIAL] or push 2 digit keys to select the memory
channel (only programmed memories can be selected).
e Push [
MW] for 2 sec. to transfer.
(S.MW)
• The contents are transferred and VFO mode is selected.
D Memory/call memory/call
q Assign the main band to the desired display with [MAIN].
w Select the memory (call) channel to be transferred:
Push [MR] (or [CALL]) to select memory (call) mode.
Rotate [DIAL] or push 2 digit keys to select the memory
channel (only programmed memories can be selected).
e Push [
MW] momentarily.
(S.MW)
• "VFO" appears in the display.
r Rotate [DIAL] to select a memory or call channel to trans-
fer the data.
t Push [
MW] for 2 sec. to transfer.
(S.MW)
• The contents are transferred and the original channel is selected.
(transferring)
6
23