Config Command - Qlogic SANbox 5200 Series User Manual

A – Command Line Interface

Config Command

Config Command
Manages the Fibre Channel configurations on a switch. For information about
setting the port and switch configurations, refer to the
page A-61.
Authority
Admin session for all keywords except List
Syntax
config
activate [config_name]
backup
cancel
copy [config_source] [config_destination]
delete [config_name]
edit [config_name]
list
restore
save [config_name]
Keywords
activate [config_name]
Activates the configuration given by [config_name]. If you omit [config_name], the
currently active configuration is used. Only one configuration can be active at a
time.
backup
Creates a file named configdata, which contains the system configuration
information. To download this file, open an FTP session, log in with account
name/password of "images" for both, and type "get configdata". Refer to
up and Restoring Switch Configurations" on page
cancel
Terminates the current configuration edit session without saving changes that
were made.
copy [config_source] [config_destination]
Copies the configuration given by [config_source] to the configuration given by
[config_destination]. The switch supports up to 10 configurations including the
default configuration.
delete [config_name]
Deletes the configuration given by [config_name] from the switch. You cannot
delete the default configuration (Default Config) nor the active configuration.
edit [config_name]
Opens an edit session for the configuration given by [config_name]. If you omit
[config_name], the currently active configuration is used.
list
Displays a list of all available configurations on the switch. This keyword does not
require an admin session.
A-16
A
"Set Config Command" on
A-4.
59056-03 C
"Backing