Appendix A Command Line Interface; Logging On To A Switch; User Accounts; A.1 Logging On To A Switch - Qlogic SANbox 5200 Series User Manual

The command line interface (CLI) enables you to perform a variety of fabric and
switch management tasks through an Ethernet or a serial port connection. This
section describes the following:
A.1

Logging On to a Switch

To log on to a switch using Telnet, open a command line window on the
workstation and enter the Telnet command followed by the switch IP address:
A Telnet window opens prompting you for a login. Enter an account name and
password.
To log on to a switch through the serial port, configure the workstation port with the
following settings:
Enter an account name and password when prompted.
59056-03 C
Command Line Interface
Logging On to a Switch

User Accounts

Working with Switch Configurations
Commands
# telnet ip_address
9600 baud
8-bit character
1 stop bit
No parity
Appendix A
A-1