Table of Contents
Advertisement
Section 2: Monitoring Enhancements
New Designations
Copying and Bouncing
Automation Moves
1 - 22
Set the edit's start and end time locations. These are set in a similar manner to
standard automation editing using the DSC Numeric Keypad and/or SpinKnob.
Press the DSC [Esc] key to back up to the Automation Edit menu, then press
[F3] (Tplt). You will now see the Automation Edit Template screen:
Notice that the normal Edit Template M1 and M2 designators have been
replaced with the CAux (CUBE Aux) and CPan (CUBE Pan) designators. These
designators are active whenever you are viewing the Automation Edit Tem-
plate. Select channel 12's [M1] key to select the source CUBE automation
channel. Next, press [F3] (View) to view the Pass Control screen. Once you
have set the start and end locations for your edit, perform a standard automa-
tion Cut. Notice that the remaining portions of automation are now joined.
Copying and Bouncing of CUBE Aux and Panner automation data to other
console channels in sync, can also be done. The steps are the same as de-
scribed above with the addition of an additional trip to the Automation Edit
Template to deselect the source data channel followed by the selection of the
destination channels and the final Bounce operation.
Euphonix CS3000/2000 MixView 3.2 Software Supplement
Advertisement
Table of Contents
